Refer to the exhibit.

The actual speed of the serial links between R2 and R3 are 256 kb/s
and 512 kb/s respectively. When configuring EIGRP on routers R2 and R3, the network
administrator configured the bandwidth of both serial interfaces to 512 kb/s. What will be the
effect? Select the best response.

Refer to the exhibit.

ROUTE.com has just implemented this EIGRP network. A network
administrator came to you for advice while trying to implement load balancing across part of their EIGRP network.
If the variance value is configured as 2 on all routers and all other metric and K values are
configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths?

Select the best response.

Refer to the exhibit.

A Boston company bought the assets of a New York company and is
trying to route traffic between the two data networks using EIGRP. The show command
output shows that traffic will not flow between the networks. As a network consultant, you
were asked to modify the configuration and certify the interoperability of the two networks.
For traffic to flow from subnet 172.16.8.0/24 to the 172.16.16.0/24 subnet, which
configuration change do you recommend?

Select the best response.

Refer to the exhibit.

A Boston company bought the assets of a New York company and is
trying to route traffic between the two data networks using EIGRP over EoMPLS. As a
network consultant, you were asked to verify the interoperability of the two networks. From
the show ip route command output, what can you tell the customer about the traffic flow
between the subnet in New York (172.16.8.0/24) and the subnets in Boston (172.16.16.0/24
and 10.10.16.0/24)?
Select the best response.

Refer to the exhibit.

You are the network administrator responsible for the NProuter, the
10.1.1.1 router, and the 10.1.1.2 router. What can you determine about the OSPF operations
from the debug output? Select the best response.

You have just completed an OSPF implementation. While executing your verification plan,
you determine that R1 is not able to establish full OSPF adjacency with R2. The show ip
ospf neighbor command output on R1 shows that R2 is stuck in the INIT state. What could
be the cause of this problem?
Select the best response.

Refer to the exhibit.

You have completed an OSPF implementation, and you are verifying
OSPF operation. You notice that router A and router B are stuck in the two-way state. From
the show ip ospf interface command output, what is the cause of this issue?
Select the best response.

You have completed an OSPF implementation, and you are verifying OSPF operation.
During this verification, you notice that the OSPF route of 172.16.10.0 is repeatedly
appearing and disappearing from the routing table. Further investigation finds that the OSPF
CPU utilization is very high and the routers are constantly performing SPF calculations. You
determine that 172.16.20.2 is the source of the 172.16.10.0 route. Using the show ip ospf
database router 172.16.20.1 command, you notice that when this show command is
performed repeatedly, the contents of the LSA change every few seconds.
What could be the cause of this problem? Select the best response.

When an OSPF design is planned, which implementation can help a router not have memory
resource issues? Select the best response.

The maximum number of routers per OSPF area typically depends on which three factors?
(Choose three.) Select 3 response(s).