which command sequence can be added to R1 to generate a default route into the OSPF domain?
which two commands would you configure in AS100 to influence AS200 to use the eBGP links more evenly?
Refer to the exhibit.
There are two eBGP links between AS100 and AS200. Currently the router A to router E link
has an average inbound load of 65% and the router B to router F link has an average
inbound load of 20%. After further investigation, it is found that traffic to the 10.10.1.16/28
subnet is using 45% of the bandwidth on the A to router E link and traffic to the
10.10.1.32/28 subnet is using 20% of the bandwidth on the A to router E link. Traffic to the
10.10.1.48/28 subnet is using 20% of the bandwidth on the B to router F link. If you want to
influence how AS200 sends traffic to AS100, which two commands would you configure in
AS100 to influence AS200 to use the eBGP links more evenly? (Choose two.)
Which of the following additions to the configuration will solve this issue?
Refer to the exhibit.
AS 65500 is running OSPF as its IGP and has two eBGP connections to the Internet
provider AS 65501. The provider requires that you advertise all of the prefixes in AS 65500
to the provider as a single 192.168.12.0/22 route. Currently only Routers A and B are able to
reach the Internet. Which of the following additions to the configuration will solve this issue?
Drag each item to its proper location.
Place the BGP commands to the proper locations
Which Ipv4-mapped Ipv6 address is equivalent to IPv6 address ::ffff:AC11:AC11?
Which Ipv4-mapped Ipv6 address is equivalent to IPv6 address ::ffff:AC11:AC11?
which statement is true?
Based on the P1R3 show ip bgp output, which statement is true?
Which three of the following are valid components in 6to4 Tunneling configuration?
To configure 6to4 tunneling on a dual-stack edge router. Which three of the following are
valid components in 6to4 Tunneling configuration? (Choose Three)
Click and drag the correct techniques for transitioning networks or devices from IPv4 to IPv6…
Which two among the following are used to indicate external type of route in routing table?
Which two among the following are used to indicate external type of route in routing table?
(Choose two.)