According to Cisco’s official best practice recommendations, what is the preferred method
for populating the BGP table on your router with IGP routes?

Your network has 2 separate T1 connections with two different providers. To support this,
BGP is being configured. The required information regarding the ISPs is shown below:
Your network: 164.67.36.0/24
Your AS number: 300
AS number of ISP1: 1005
AS number of ISP2: 1010
Based on the information provided, which of the following commands would you enter to
advertise your network to ISP1 and ISP2 via BGP?

You wish to permit all BGP prefixes between /10 and /18 for the 207.0.0.0 network. How
should a BGP prefix list be configured to do this?

Routers PG1 and PG 2 are configured for BGP as shown below:
RTR PG 1
router bgp 200
neighbor 183.215.22.1 remote-as 200
neighbor 183.215.22.1 update-source loopback 1
RTR PG 2
router bgp 200
neighbor 147.229.1.1 remote-as 200
These two routers currently have an active BGP peering session between them and they are
able to pass routes to each other. Based on these configuration files, which of the following
are true? (Select three)

The ABC Company BGP router is configured as shown below:
router bgp 64000
neighbor 172.16.1.1 remote-as 64000
neighbor 10.1.1.2 remote-as 64550
network 200.52.1.192 mask 255.255.255.224
no synchronization
aggregate-address 200.52.1.0 255.255.255.0
The BGP peers 172.16.1.1 and 10.1.1.2 in the above configuration are established and
working, as well as the interface with IP address 200.52.1.192. Based on this information,
which statement below is true about your configuration?

Which IOS command could you use to verify if a BGP router is or isn’t a route reflector?

While verifying BGP operation on the ABC Company router, you issue the “show ip bgp”
command as shown below:
router PG >show ip bgp
BGP table version is 1046033, local router ID is 198.32.162.100
Status codes: s suppressed, d damped, h history, * valid, > best, i internal Origin codes: i
IGP, e EGP, ?
Incomplete

From the information above, which path will the network 143.16.0.0 prefer to take to exit the
AS?

One of the ABC Company routers is unable to form a neighbor relationship with an external
BGP peer. Which two statements are true about external BGP neighbor relationships?
(Select two)

The ABC Company network uses the autoconfiguration feature in their IPv6 network. Which
statement best describes autoconfiguration for IPv6?

You wish to represent some IPv6 networks in a shorter form. What number is a valid
representation for the 200F:0000:AB00:0000:0000:0000:0000/56 IPv6 prefix?