Which interoperability technique implemented on the dual-stack routers would allow connectivity between IPv6 s
What is the metric that is assigned to redistributed BGP routes?
If a metric is not specified for routes that are redistributed into OSPF, the default metric that
is assigned to the routes is 20, except for redistributed BGP routes. What is the metric that is
assigned to redistributed BGP routes?
What are two possible causes?
During a redistribution of routes from OSPF into EIGRP, an administrator notices that none
of the OSPF routes are showing in EIGRP. What are two possible causes? (Choose two.)
Which IS-IS router is equivalent to an ABR in OSPF?
Which IS-IS router is equivalent to an ABR in OSPF?
Drag the appropriate IS-IS routing term to its correct definition.
Redistribute EIGPR routes into IS-IS as Level-1 routes…
Which two networks does the SW1 device have feasible successors for?
Which three EIGRP routes will be installed for the 172.17.3.128/25 and 172.17.2.0/24 networks?
Refer to the exhibit. BigBids Incorporated is a worldwide auction provider. The network uses
EIGRP as its routing protocol throughout the corporation. The network administrator does
not understand the convergence of EIGRP. Using the output of the show ip eigrp topology
all-links command, answer the administrator’s questions.
Which three EIGRP routes will be installed for the 172.17.3.128/25 and 172.17.2.0/24
networks? (Choose three)
A: 172.17.3.128.25 [90/28160] via 172.17.1 2, 01:26:35, FastEthernet0/2
B: 172.17.3.128/25 [90/30720] via 172.17.3.2, 01:26:35. FastEthemet0/3
C: 172.17.3.128/25 [90/30720] via 172.17.10.2, 01:26:35. FastEthernet0/1
D: 172.17.2.0/24 [90/30720] via 172.17.10.2, 02:10:11, FastEthernet0/1
E: 172.17.2.0/24 [90/28160] via 172.17.10.2, 02:10:11. FastEthernet0/1
F: 172.17.2.0/24 [90/33280] via 172.17.3.2, 02:10:11. FastEthernet0/3
Which three networks is the router at 172.17.10.2 directly connected to?
Refer to the exhibit. BigBids Incorporated is a worldwide auction provider. The network uses
EIGRP as its routing protocol throughout the corporation. The network administrator does
not understand the convergence of EIGRP. Using the output of the show ip eigrp topology
all-links command, answer the administrator’s questions.
Which three networks is the router at 172.17.10.2 directly connected to? (Choose three)
A: 172.17.0.0/30
B: 172.17.1.0/24
C: 172.17.2.0/24
D: 172.17.3.0/25
E: 172.17.3.128/25
F: 172.17.10.0/24
You are tasked with identifying the cause of this fault and implementing the needed corrective actions…
SIMULATION
LAB. (IPv6 OSPF Virtual Link Simulation)
Acme is a small export company that has an existing enterprise network that is running IPv6
OSPFv3. Currently OSPF is configured on all routers. However, R4’s loopback address
(FEC0:4:4) cannot be seen in R1’s IPv6 routing table. You are tasked with identifying the
cause of this fault and implementing the needed corrective actions that uses OSPF features
and does no change the current area assignments. You will know that you have corrected
the fault when R4’s loopback address (FEC0:4:4) can ping from R1 to R4 loopback address.
Special Note: To gain the maximum number of points you must remove all incorrect or
unneeded configuration statements related to this issue.