Which action configures PSTN backup for calls that are …
Which action configures PSTN backup for calls that are rejected by the gatekeeper CAC?
Which two are gatekeeper-controlled trunk options that …
Which two are gatekeeper-controlled trunk options that support gatekeeper call administration control? (Choose two.)
Which task must you perform before deleting a transcoder?
Which task must you perform before deleting a transcoder?
Which codec do you configure in Cisco Unity Communicati…
You are deploying a remote office setup that connects with Cisco Unity Communications Manager at a hub location. You have an available dedicated bandwidth of
20% from the 2-Mb/s WAN circuit for VoIP that supports a maximum of 17 calls. Which codec do you configure in Cisco Unity Communications Manager to achieve
this?
The relationship between a Region and a Location is tha…
The relationship between a Region and a Location is that the Region codec parameter is combined with Location bandwidth when communicating with other
Regions.
Which two statements describe RSVP-enabled locations-ba…
Which two statements describe RSVP-enabled locations-based CAC? (Choose two.)
Which two conditions can correct this issue?
Refer to the exhibit. A user in RTP calls a phone in San Jose during congestion with Call Forward No Bandwidth (CFNB) configured to reach cell phone
4085550150. The user in RTP sees the message “Not Enough Bandwidth” on their phone and hears a fast busy tone. Which two conditions can correct this issue?
(Choose two.)
The relationship between a Region and a Location is tha…
The relationship between a Region and a Location is that the Region codec parameter is used between a Region and its configured Locations.
Which statement is correct about AAR?
Which statement is correct about AAR?
Which command needs to be edited to allow the transcode…
Refer to the exhibit. You have configured transcoder resources in both an IOS router and a Cisco Unified Communications Manager. When you review the
configurations in both devices the IP addresses and transcoder names are correct, but the transcoder is failing to register with the Cisco Unified Communications
Manager. Which command needs to be edited to allow the transcoder to register properly?