Which configuration output indicates a properly configured T1 digital voice interface?
Which configuration output indicates a properly configured T1 digital voice interface?
Which Cisco Unified Communications Manager is used for incoming calls through an MGCP gateway?
Which three statements about the default VoIP dial peer are true?
Which three statements about the default VoIP dial peer are true? (Choose three.)
you need to add to dial peer to solve this issue? dial-peer voice 3 pots destination-pattern 6… preference 1
Refer to the exhibit and configuration output.
A user in New York (5001) is trying to call a user in London (6001), but the call cannot be completed.
Assuming that the WAN uplink is failing and the voice traffic has to go out toward the PSTN, which
command do you need to add to dial peer to solve this issue?
dial-peer voice 3 pots
destination-pattern 6…
preference 1
port 0/0/0:23
dtmf-relay sip-notify
Which four commands are required to configure the translation profile?
You are a Voice Engineer at ABC Company. You want to implement a voice translation profile to perform
the following manipulation: The incoming DNIS 9876562XXX should be modified to 2XXX. Which four
commands are required to configure the translation profile? (Choose four.)
How do you configure calling privileges on Cisco Unified Communications Manager Express?
How do you configure calling privileges on Cisco Unified Communications Manager Express?
Which three CLI commands allow you to verify the correct VoIP dial-peer matching?
Which three CLI commands allow you to verify the correct VoIP dial-peer matching? (Choose three.)
Which three are functions of Cisco Unified Border Element?
Which three are functions of Cisco Unified Border Element? (Choose three.)
Which two configuration items are necessary to configure Cisco Unified Border Element for video?
Which two configuration items are necessary to configure Cisco Unified Border Element for video?
(Choose two.)
Which command is used to enter the DSP farm profile configuration mode?
Which command is used to enter the DSP farm profile configuration mode?