Which statement about access lists that are applied to an interface is true?

Which item represents the standard IP ACL?

A network administrator is configuring ACLs on a Cisco router, to allow traffic from hosts on
networks 192.168.146.0, 192.168.147.0, 192.168.148.0, and 192.168.149.0 only. Which two
ACL statements, when combined, would you use to accomplish this task? (Choose two.)

What can be done to secure the virtual terminal interfaces on a router? (Choose two.)

Which two commands correctly verify whether port security has been configured on port
FastEthernet 0/12 on a switch? (Choose two.)

Refer to the exhibit.

The following commands are executed on interface fa0/1 of 2950Switch.
2950Switch(config-if)# switchport port-security
2950Switch(config-if)# switchport port-security mac-address sticky
2950Switch(config-if)# switchport port-security maximum 1
The Ethernet frame that is shown arrives on interface fa0/1. What two functions will occur
when this frame is received by 2950Switch? (Choose two.)

What will be the result if the following configuration commands are implemented on a Cisco
switch?
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security mac-address sticky

DRAG DROP
Drag each category on the left to its corresponding router output line on the right. Each router output line is the result of a shown ip interface command.

DRAG DROP
Drag each procedure on the left to its proper category on the right.

Refer to the exhibit.

A network administrator attempts to ping Host2 from Host1 and receives the results that are
shown. What is the problem?