Which two locations can be configured as a source for the IOS image in the boot system
command? (Choose two.)

Refer to the exhibit.

Given the output for this command, if the router ID has not been manually set, what router ID
will OSPF use for this router?

Refer to the exhibit.

What commands must be configured on the 2950 switch and the router to allow
communication between host 1 and host 2? (Choose two.)

Which two statements describe the process identifier that is used in the command to
configure OSPF on a router? (Choose two.)
Router(config)# router ospf 1

Refer to the exhibit.

For what two reasons has the router loaded its IOS image from the location that is shown?
(Choose two.)

Refer to the exhibit.

What can be determined about the router from the console output?

Which three elements must be used when you configure a router interface for VLAN
trunking? (Choose three.)

Which commands are required to properly configure a router to run OSPF and to add
network 192.168.16.0/24 to OSPF area 0? (Choose two.)

A router receives information about network 192.168.10.0/24 from multiple sources. What
will the router consider the most reliable information about the path to that network?

What is the default maximum number of equal-cost paths that can be placed into the routing
table of a Cisco OSPF router?