Refer to the exhibit.

A network administrator configures a new router and enters the copy startup-config runningconfig command on the router. The network administrator powers down the router and sets it
up at a remote location. When the router starts, it enters the system configuration dialog as
shown. What is the cause of the problem?

What is the default administrative distance of OSPF?

Which characteristics are representative of a link-state routing protocol? (Choose three.)

Refer to the exhibit.

Based on the exhibited routing table, how will packets from a host within the
192.168.10.192/26 LAN be forwarded to 192.168.10.1?

Refer to the exhibit.

C-router is to be used as a “router-on-a-stick” to route between the VLANs. All the interfaces
have been properly configured and IP routing is operational. The hosts in the VLANs have
been configured with the appropriate default gateway. What is true about this configuration?

Refer to the exhibit.

Why is flash memory erased prior to upgrading the IOS image from the TFTP server?

Which command would you configure globally on a Cisco router that would allow you to view
directly connected Cisco devices?

Refer to the exhibit.

According to the routing table, where will the router send a packet destined for 10.1.5.65?

Refer to the exhibit.

Which address and mask combination represents a summary of the routes learned by
EIGRP?

Refer to the exhibit.

Assuming that the entire network topology is shown, what is the operational status of the
interfaces of R2 as indicated by the command output shown?