What would be the effect of Issuing the command ip access-group 115 in on the s0/0/1 interface?
No host could connect to RouterC through s0/0/1.
Telnet and ping would work but routing updates would fail.
FTP, FTP-DATA, echo, and www would work but telnet would fail.
Only traffic from the 10.4.4.0 network would pass through the interface.

The task is to identify the fault(s) and correct the router configuration(s) to provide full connectivity between the routers.

A network associate is configuring a router for the weaver company to provide internet access. The
ISP has provided the company six public IP addresses of 198.18.184.105 198.18.184.110. The
company has 14 hosts that need to access the internet simultaneously. The hosts in the company
LAN have been assigned private space addresses in the range of 192.168.100.17 – 192.168.100.30.

Central Florida Widgets recently installed a new router in their office. Complete the network
installation by performing the initial router configurations and configuring R1PV2 routing using the
router command line interface (CLI) on the RC.
Configure the router per the following requirements:
Name of the router is R2
Enable. secret password is cisco
The password to access user EXEC mode using the console is cisco2
The password to allow telnet access to the router is cisco3
IPV4 addresses mast be configured as follows:
Ethernet network 209.165.201.0/27 – router has fourth assignable host address in subnet
Serial network is 192.0.2.176/28 – router has last assignable host address in the subnet.
Interfaces should be enabled.
Router protocol is RIPV2
Attention:
In practical examinations, please note the following, the actual information will prevail.
1. Name or the router is xxx
2. EnablE. secret password is xxx
3. Password In access user EXEC mode using the console is xxx

4. The password to allow telnet access to the router is xxx
5. IP information

The task is to create and apply an access-list with no more than three statements that will allow ONLY host C web access to the Finance Web Server.

The task is to create and apply an access-list with no more than three statements that will allow ONLY host C web access to the Finance Web Server.

What are three reasons to collect Netflow data on a company network? (Choose three.)

LAB – SIMULATION
The task is to create and apply an access-list with no more than three statements that will allow ONLY host C web access to the Finance Web Server.

What Netflow component can be applied to an interface to track IPv4 traffic?

What Cisco IOS feature can be enabled to pinpoint an application that is causing slow network
performance?