What command is used to verify the DLCI destination address in a Frame Relay static configuration?
What command is used to verify the DLCI destination address in a Frame Relay static
configuration?
What does this mean?
The output of the show frame-relay pvc command shows “PVC STATUS = INACTIVE”. What does
this mean?
What is the cause of the problem?
Refer to the exhibit.
A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise,
the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but
the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts
have been verified as correct. What is the cause of the problem?
What does the frame-relay interface-dlci command configure?
What does the frame-relay interface-dlci command configure?
which statement is correct?
Refer to the exhibit.
The show interfaces serial 0/1 command was issued on the R10-1 router. Based on the output
displayed which statement is correct?