Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to O
Which commands are required to properly configure a router to run OSPF and to add network
192.168.16.0/24 to OSPF area 0? (Choose two.)
maximum Maximum number of parallel routes that OSPF can install in a routing
table. The range is from 1 to 16 routes.
What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OS
What is the default maximum number of equal-cost paths that can be placed into the routing
table of a Cisco OSPF router?
what configuration error is causing this problem?
A network administrator is trying to add a new router into an established OSPF network. The
networks attached to the new router do not appear in the routing tables of the other OSPF
routers. Given the information in the partial configuration shown below, what configuration
error is causing this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0
what is the cause of this problem?
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The
routers cannot establish an adjacency relationship on their common Ethernet link.
The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.
Based on the information in the graphic, what is the cause of this problem?
How will the default route configured on R1 affect the operation of R2?
What are the characteristics of OSPF areas?
OSPF routing uses the concept of areas. What are the characteristics of OSPF areas? (Choose
Three.)
Which two statements are true about the loopback address that is configured on RouterB?
Which characteristics are representative of a link-state routing protocol?
Which characteristics are representative of a link-state routing protocol? (Choose three.)
Which routers are likely to have been elected as DR?
The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the
graphic. There is concern that a lack of router resources is impeding internetwork performance.
As part of examining the router resources, the OSPF DRs need to be known. All the router OSPF
priorities are at the default and the router IDs are shown with each router.
Which routers are likely to have been elected as DR? (Choose two.)