Which commands will correct this issue?
The hosts in the LAN are not able to connect to the Internet. Which commands will correct this
issue?
what is the most likely cause of the problem?
The network administrator has found the following problem.
The remote networks 172.16.10.0, 172.16.20.0, and 172.16.30.0 are accessed through the
Central router’s serial 0/0 interface. No users are able to access 172.16.20.0. After reviewing
the command output shown in the graphic, what is the most likely cause of the problem?
What is the status of the switch?
Refer to the exhibit.
After the power-on-self test (POST), the system LED of a Cisco 2950 switch turns amber.What is
the status of the switch?
Why did the device return this message?
Refer to the exhibit.
Why did the device return this message?
What would be the most effective steps to troubleshoot this physical layer problem?
Refer to the exhibit.
The two connected ports on the switch are not turning orange or green. What would be the
most effective steps to troubleshoot this physical layer problem? (Choose three.)
The host on Network A can communicate with other hosts on Network
Refer to the exhibit.
A person is trying to send a file from a host on Network A of the JAX Company to a server on
Network Z of the XYZ Company. The file transfer fails. The host on Network A can communicate
with other hosts on Network A.
Which command, issued from router RTA, would be the most useful for troubleshooting this
problem?
What is the most likely cause of the problem?
Refer to the exhibit.
A user cannot reach any web sites on the Internet, but others in the department are not having
a problem.
What is the most likely cause of the problem?
what is the most likely cause of this problem?
Refer to the exhibit.
A network administrator is troubleshooting a connectivity problem on the serial interfaces. The
output from the show interfaces command on both routers shows that the serial interface is
up, line protocol is down. Given the partial output for the show running-config in the exhibit,
what is the most likely cause of this problem?
What should be done to correct this situation?
Refer to the exhibit.
The DHCP settings have recently been changed on the DHCP server and the client is no longer
able to reach network resources. What should be done to correct this situation?
What conclusions can be made about this design?
Refer to the exhibit.
A network technician is asked to design a small network with redundancy. The exhibit
represents this design, with all hosts configured in the same VLAN. What conclusions can be
made about this design?