R1 is configured with the default configuration of OSPF. From the following list of IP addresses
configured on R1, which address will the OSPF process select as the router ID?

ROUTER# show ip route
192.168.12.0/24 is variably subnetted, 9 subnets, 3 masks
C 192.168.12.64 /28 is directly connected, Loopback1
C 192.168.12.32 /28 is directly connected, Ethernet0
C 192.168.12.48 /28 is directly connected, Loopback0
O 192.168.12.236 /30 [110/128] via 192.168.12.233, 00:35:36, Serial0
C 192.168.12.232 /30 is directly connected, Serial0
O 192.168.12.245 /30 [110/782] via 192.168.12.233, 00:35:36, Serial0
O 192.168.12.240 /30 [110/128] via 192.168.12.233, 00:35:36, Serial0
O 192.168.12.253 /30 [110/782] via 192.168.12.233, 00:35:37, Serial0

O 192.168.12.249 /30 [110/782] via 192.168.12.233, 00:35:37, Serial0
O 192.168.12.240/30 [110/128] via 192.168.12.233, 00:35:36, Serial 0
To what does the 128 refer to in the router output above?

Which of the following describe the process identifier that is used to run OSPF on a router?
(Choose two)

Which address are OSPF hello packets addressed to on point-to-point networks?

Some routers have been configured with default routes. What are some of the advantages of
using default routes? (Choose two)

Refer to the exhibit.

PC1 pings PC2. What three things will CORE router do with the data that is received from PC1?
(Choose three.)

Which three statements are correct about RIP version 2? (Choose three)

Refer to the exhibit.

Why are two OSPF designated routers identified on Core-Router?

What is the OSPF default frequency, in seconds, at which a Cisco router sends hello packets on a
multi-access network?

Which parameter or parameters are used to calculate OSPF cost in Cisco routers?