By default, which BGP path attribute is stripped in the outgoing IBGP updates?

The purpose of the bgp always-compare-med command is to compare the MED ______.

Given the following:
router bgp 65102
neighbor 10.1.1.1 remote-as 65103
neighbor 10.2.2.2 remote-as 65104
neighbor 172.16.1.4 remote-as 65102
neighbor 10.1.1.1 route-map setlp in
!
route-map setlp permit 10
match community 1
set local-preference 150
!
route-map setlp permit 20
!
ip community-list 1 permit 65103:150
What will the configuration on R1 accomplish?

What are two methods used to configure the local-preference BGP path attribute on Cisco routers? (Choose two)

What is the correct BGP configuration to have AS 65111 prefer the path to AS 65221 over the path to AS 65237 except for the traffic which originates in AS 65237?

Complete the BGP configuration on Certkiller 1 so that the show ip bgp output reflects the following path selection?
Certkiller 1#show ip bgp
BGP table version is 9, local router ID is 172.16.10.1 Status codes: s suppressed, d damped, h history, *valid, > best, i – internal
Origin codes: i – IGP, e – EGP, ? – incomplete
Network Next Hop Metric LocPrf Weight Path
*> 172.20.0.0 10.10.20.1 150 65123 65122 i
* 10.10.10.2 0 120 65122 i
*> 172.25.0.0 10.10.21.1 150 65123 65124 i
* 10.10.10.2 120 65122 65124 i
*> 172.30.0.0 10.10.21.1 0 150 65123 i
* 10.10.10.2 120 65122 65123 I
hostname Certkiller 1
!
router bgp 65121
neighbor 10.10.10.2 remote-as 65122
neighbor 10.10.20.1 remote-as 65123
________________________

Which BGP path attribute is only used within the local router and NOT shared between all the BGP routers within the AS?

Which four attributes are used by BGP to detect routing loops? (Choose four.)

What type of BGP path attributes are propagated to BGP peers with the partial bit set even if they are not recognized?

Which condition must be met before Route Refresh messages can be sent to a BGP peer?