The Ethernet 0 interface of a router was configured with address 10.64.0.1 255.224.0.0 while the Ethernet 1 interface was configured with address 10.96.0.1/11. Which commands could be used to configure RIP version 1 on this router to advertise both networks to neighboring routers? (Choose two.)

Which of the following are true regarding the command output shown in the display? (Choose two.)

The speed of all serial links is E1 and the speed of the all other links is 100Mb/s. A static route will be established on the Manchester router to direct traffic toward to the internet over the most direct path available. What configuration of the Manchester router will establish a route toward to the internet for traffic from workstation on the Manchester LAN?

Which parameter can be tuned to affect the selection of a static route as a backup when a dynamic protocol is also being used?

Which of the following are true regarding the debug output shown in the graphic? (Choose Two)

Which two statements are characteristics of a distance vector routing protocol? (Choose two)

What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway-Router?

Which two statements describe the advantages to the use of RIP over the use of OSPF? (Choose two)

A medium-sized company has a Class C IP address. It has two Cisco routers and one non-Cisco router. All three routers are using RIP version 1. The company network is using the block of 198.133.219.0/24. The company has decided it would be a good idea to split the network into three smaller subnets and create the option of conserving addresses with VLSM. What is the best course of action if the company wants to have 40 hosts in each of the three subnets?

Refer to the graphic:

Host 1 cannot receive packets from Host 2. Assuming that RIP v1 is the routing protocol in use, what is wrong with the IP configuration information shown? (Choose two.)