Refer to the exhibit. Which WAN protocol is being used?

Refer to the exhibit. What type of connection would be supported by the cable diagram shown?
Pin Number
Color
Function

Color
Function
1
White/Green
TX+
1
White/Green
TX+
2
Green
TX-
2
Green
TX-
3
White/Orange
RX+
3
White/Orange
RX+
6
Orange
RX-
6
Orange
RX-

Refer to the exhibit.

Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs.
What is needed to allow communication between VLANs?

Refer to the exhibit.

What two facts can be determined from WLAN diagram? (choose two)

Refer to the exhibit.

A network administrator is adding two new hosts to SwitchA.

Which three values could be used for the configuration of these hosts? (Choose three)

Refer to the exhibit.

Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0/10 is not the root port for VLAN2?

Refer to the exhibit. A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings to SwitchB. Later attempts to access NewSwitch using Telnet from SwitchA failed. Which statement is true?

When two hosts are trying to communicate across a network, how does the host originating the communication determine the hardware address of the host that it wants to "talk" to?

Refer to the exhibit.

A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network throught port fa0/1.
If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observe the output from these two show commands.

Which two of these changes are necessary for SwitchA to meet the requirements? (Choose two)

Refer to the exhibit. Which (config-router) command will allow the network represented on the interface to be advertised by RIP?