which one of the routes would forward a packet destined for 10.1.1.1?
Click the Exhibit button to view the routing table.
If a router had the three routes listed, which one of the routes would forward a packet destined for 10.1.1.1?
What is the worst case optical signal-to-noise ratio (OSNR) of Channel 1 at 0.5nm away from the peak?
Click the Exhibit button to view the graph.
The graph represents optical signal power versus wavelength measurement from 1550nm to 1560nm. What is the worst case optical signal-to-noise ratio (OSNR) of Channel 1 at 0.5nm away from the peak?
Which are correct timing configurations for 7600 interfaces (A) and (B)?
Click the Exhibit button.
The exhibit shows OC-12 POS connections across various transport media. Which are correct timing configurations for 7600 interfaces (A) and (B)? (Note: connection between routers B and C is set to
internal timing.)
what is the wavelength of the next lower frequency based on a 50GHz channel plan?
Using the ITU-T channel plan recommendation defined in G.692, if one of the channels has a frequency of 196.10THz (equivalent to 1528.77nm), then what is the wavelength of the next lower frequency based on a 50GHz channel plan?
what type of transport architecture is best suited for creating an OC-12 RPR ring with 4 Cisco 12000 nodes?
Click the Exhibit button.
In a customer access ring environment, what type of transport architecture is best suited for creating an OC-12 RPR ring with 4 Cisco 12000 nodes?
what node would you put a static route to access this network from an external IP network?
Click the Exhibit button.
With a router connected to node E, and a laptop connected to node C, in what node would you put a static route to access this network from an external IP network?
What do directly modulated transponders vary to the laser in order to transmit an optical signal?
What do directly modulated transponders vary to the laser in order to transmit an optical signal?
What is the difference in power at the input and the output of the device.under test?
What is the difference in power at the input and the output of the device
under test?
Which three are examples of a non-linear effect?
Which three are examples of a non-linear effect? (Choose Three)
what IP address should Host G use for its default gateway?
Click the Exhibit button to view the topology.
Routers E and F are running HSRP (Hot Standby Router Protocol). Router E has a higher priority, and both routers have standby preempt configured. Since Router E is normally the active router, what IP address should Host G use for its default gateway?
