when is the extinction ratio acceptable?
Click the Exhibit button to view the diagram.
In the OC-48 signal shown, when is the extinction ratio acceptable?
What happens?
Click the Exhibit button to view the topology.
Routers E and F are configured for HSRP (Hot Standby Routing Protocol). E has a priority of 100, while F has a priority of 50. At one point, when E is the active router, it fails, and F takes over as the active router. A few minutes later, E returns to service. What happens?
Calculate the gain of an amplifier if 1 watt is applied to the imput and 2 watts is measured at the output:
Calculate the gain of an amplifier if 1 watt is applied to the imput and 2 watts is measured at the output:
which is the highest level of priority in the Intelligent Protection Switching (IPS) hierarchy?
In a Resilient Packet Ring architecture, which is the highest level of priority in the Intelligent Protection Switching (IPS) hierarchy?
what occurs?
Click the Exhibit button.
When the G-series card Rx interface at “A” in the diagram loses it’s receive signal, what occurs?
How should OSPF be configured on Router B?
Click the Exhibit button to view the scenario.
How should OSPF be configured on Router B?
Where is the administrative unit pointer found in the STM-1 signal in SDH?
Where is the administrative unit pointer found in the STM-1 signal in SDH?
What significant value to VSANs contribute?
What significant value to VSANs contribute?
If this router has a configuration-register setting of 0x102, select the proper boot sequence
Click the Exhibit button to view the confiuration.
Look at the router configuration above. If this router has a configuration-register setting of 0x102, select the proper boot sequence:
For Dispersion Shifted Fiber (DSF), the zero-dispersion wavelength generally occurs in the range:
For Dispersion Shifted Fiber (DSF), the zero-dispersion wavelength generally occurs in the range: