Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards, the exhibit shows your configuration in a local switch1. However, EtherChannel is not coming up. Which one of these statements could be a possible reason?

Refer to the exhibit. You are asked to enable redirection for a network optimization engine that will be connected directly to your company CPE. What is the correct configuration to enable redirection for traffic optimization?

Refer to the exhibit. Users from the Engineering VLAN complain that every time Business VLAN users have a network connectivity issue, the Engineering VLAN users usually have problems experiencing slow response or network connectivity problems. After troubleshooting, an unauthorized switch 2 was found. This unauthorized switch has been a regular problem, assuming the root bridge function under the spanning-tree domain and causing the

Engineering VLAN to be unstable. Which three of these actions could be suggested to fix the problem?

Refer to exhibits 1 and 2. A company uses a Metro Ethernet (Gigabit Ethernet) dedicated circuit to communicate between users (subnet B) and servers (subnet A) as shown in Exhibit 1. Both routers use OSPF to advertise the subnets. During a weekly management meeting, they realize that the WAN link is oversize. They have been using only 2 Mb/s in the worst-case scenario. So they propose a new, cheaper WAN connection using a 2-Mb/s Frame-Relay point-to-point link to interconnect both sites (Exhibit 2). The Frame Relay service provider informs them that multicast traffic is not allowed to run over the service provider network. Which one of these options is best to enable the company to establish the OSPF neighbor adjacency?

Refer to exhibits 1 and 2. In exhibit 1, all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2, the network management team reported that there is no utilization on the WAN link B. To solve this problem, you decide to change the logical topology of your LAN, but you are not sure about what changes must be made. You must manage HSRP or change it to another protocol in order to provide the most scalable design, automatic redundancy, and load balancing. Which one of these actions would be the best choice?

Refer to the exhibit. Look at the command output. Assume that there is no other path, and the configuration is correct. What would be the consequences of this situation?

Refer to the exhibit. Look at the command output. What would be the most probable reason for this port-ID mismatch?

Refer to the exhibit. BGP-4 routing to the Internet, in normal behavior, may create asymmetrical routing for different prefixes. The BGP routing table indicates that traffic should follow the paths indicated in the exhibit, but packets are not going further than the border router in AS 4. What could be the cause of this problem?

Refer to the exhibit. Router E learned about the PIM RP (designated as 7.7.7.7) from four different sources. Routers A and D advertised the 7.0.0.0 network via EIGRP. Routers B and C advertised the 7.0.0.0 network via OSPF. Considering that all four Ethernet interfaces on

router E could potentially lead back to the PIM-RP, when router E receives the first multicast packet down the shared tree, which incoming interface will be used to successfully pass the RPF check?

Refer to the exhibit. Users on the 199.155.24.0 network are unable to reach the 172.16.10.0 network. What is the most likely solution?