There is some confusion on this sim and what it is. So I will tell you that it is a window with 4 squares on the left side. Click each one to see the question. Again, there are 4 questions and one topology. Click the topology button at the bottom of the sim to see it. There is only one topology for all 4 questions. You do NOT log into any routers. All configuration is provided as text in the question.

NOTE: The actual topology may vary with the routing protocol questions selected for the sim and the number of routers could be as high as R6

Look at the configuration in R3. Of the following routes (30.30.0.0/16, 40.40.0.0/16, and 200.200.0.0/16) Which ones will show up in R2?

Relevant R3 config is the following:
router BGP 1000
neighbor {R2 Loop IP address} remote-as 10
neighbor {R2 Loop IP address} route-map BGP out
neighbor {R2 Loop IP address} send community
route-map 5 BGP permit
match ip address 1
set community no export
route-map 10 BGP permit
access-list 1 30.0.0.0 0.255.255.255

There is some confusion on this sim and what it is. So I will tell you that it is a window with 4 squares on the left side. Click each one to see the question. Again, there are 4 questions and one topology. Click the topology button at the bottom of the sim to see it. There is only one topology for all 4 questions. You do NOT log into any routers. All configuration is provided as text in the question.

NOTE: The actual topology may vary with the routing protocol questions selected for the sim and the number of routers could be as high as R6

which one is the Designated Router router ID?

An example of show ip ospf database will be given

There is some confusion on this sim and what it is. So I will tell you that it is a window with 4 squares on the left side. Click each one to see the question. Again, there are 4 questions and one topology. Click the topology button at the bottom of the sim to see it. There is only one topology for all 4 questions. You do NOT log into any routers. All configuration is provided as text in the question.

NOTE: The actual topology may vary with the routing protocol questions selected for the sim and the number of routers could be as high as R6

which type of the LSA will be added in the OSPF broadcast network type?

NTP will allow you to establish which three relationships between two networking devices?

A network administrator has applied the NTP peer statement to a Cisco IOS router. Which additional function is simultaneously being used on this router?

What are two benefits of applying WRED? (Choose two.)

Which three multicast types or features are associated with a (*,G) multicast entry? (Choose three.)

After enabling Frame-Relay traffic sahping on a WAN interface by use of the following settings: CIR 768 Kb/s, Bc = 2000, Be = 7680. The correct Tc is:

QPPB is an acronym for QoS Policy Propogation via BGP. QPPB allows which of these marking behaviors?

For the following options, whoch feature monitors the level of each traffic type in 1 second intervals