Which set of Cisco Internetwork Operating System (IOS) commands is used on Cisco routers to set a
password for Telnet lines?

The output of the show ip route command is given:
Router# show ip route
Gateway of last resort is 10.119.254.240 to network 10.140.0.0
O 172.16.0.0 [110/5] via 10.19.24.6, 0:01:00, Ethernet2
B 172.17.12.0 [200/128] via 10.19.24.24, 0:02:22, Ethernet2
O 172.71.13.0 [110/5] via 10.19.24.6, 0:00:59, Ethernet2
O 10.13.0.0 [110/5] via 10.19.24.6, 0:00:59, Ethernet2
What does the value 110 in the output represent?

What is the purpose of frame tagging in Virtual LAN (VLAN) configurations?

Which statement best describes a converged network?

Which of the following represents the correct method of assigning an IP address and default gateway to a
switch?

Which command was used to create the following configuration?

Which of the following statements are true with regard to the network shown in the exhibit? (Click the Exhibit(s)
button.)

You are the switch administrator for InterConn. The network is physically wired as shown in the diagram. You
are planning the configuration of STP. The majority of network traffic runs between the hosts and servers within
each VLAN.

You would like to designate the root bridges for VLANS 10 and 20. Which switches should you designate as the
root bridges?

Which of the following is NOT true of the Cisco APIC-EM?

Which type of IP address is a registered IP address assigned by the Internet Service Provider (ISP), and
represents one or more inside local IP addresses externally?