DRAG DROP
Click and drag the command line tools used to troubleshoot the network problems on the left to their associated
functions on the right. Not all commands may be used.
Select and Place:

You set up several routers in your lab. Two of them are connected back to back using Data TerminalEquipment (DTE)-to-Data Circuit-terminating Equipment (DCE) cable. You need to configure the clock rate.
On which router would you configure the clock rate?

Which of the following are characteristics of Open Shortest Path First (OSPF)? (Choose three.)

DRAG DROP
Click and drag the command(s) used to configure passwords on a Cisco router to their appropriate purposes.
(Not all options will be used.)
Select and Place:

You are troubleshooting a problem with two routers configured in a HSRP group. You intended to configure the
routers so that Router A and Router B would each track their respective Fa0/1 interfaces and decrement their
priorities for several VLAN groups if the tracked interface went down. However, you find that Router A is not
taking over as the active device for the HSRP group on VLAN 101 when the Fa0/1 interface on Router B fails.
Which command would NOT be useful for discovering the problem?

Router 5 has four interfaces. The networks hosted on each interface are as follows:
Fa0/1 192.168.5.4/29
Fa0/2 192.168.6.0/24
Fa0/3 192.168.7.0/24
S0/0 172.16.5.0/24
You execute the following commands on the router:
Router5(config)# router bgp 20
Router5(config-router)# network 192.168.5.0
Router5(config-router)# network 192.168.6.0
Router5(config-router)# network 192.168.7.0
Router5(config-router)# network 172.16.5.0
Router5(config-router)# neighbor 172.16.5.2 remote-as 50
Router5(config-router)# aggregate-address 192.168.5.0 255.255.252.0
After this command sequence is executed, what routes will be present in the routing table of the router at
172.16.5.2? (Choose all that apply.)

To minimize routing protocol traffic, you have decided to use static routing in the network displayed in the
following diagram.

You would like to keep the configuration as simple as possible.Which command(s) are required for all hosts to communicate with one another and the Internet? (Choose all
that apply.)

You have implemented the following IP SLA configuration, as shown in the following partial output of the show
run command:
ip sla 1
dns cow.cisco.com name-server 10.52.128.30
ip sla schedule 1 start-time now
Which of the following statements is true of this configuration?

Which Cisco IOS command will display the following partial output?

Which commands would be used to enable Enhanced Interior Gateway Routing Protocol (EIGRP) on a router,
and configure the IP addresses 10.2.2.2 and 192.168.1.1 as a part of complete EIGRP configuration? (Choose
three.)