Which command(s) will enable you to configure only serial interface 0 on a Cisco router?

Which of the following situations could cause a switch to enter initial configuration mode upon booting?

You have a Telnet session established with a switch from a router. You would like to maintain that connection
while you return to the session with the router, and then easily return to the switch session after connecting to
the router.
What command should you use?

The execution of the show interfaces command yields the following as a part of its output:
Ethernet 0/0 is up, line protocol is down
Which of the following can be determined from this output?

A new switch is added to the network, and several production VLANs are shut down.
Which of the following is a probable cause for this scenario? (Choose two.)

Router-A# show running-configuration s0/0
interface serial0/0
description connected to router A
IP address 10.10.10.1 255.0.0.0
encapsulation frame-relay
shutdown
clock rate 64000
Based on the interface configuration provided, which two statements are TRUE? (Choose two.)

DRAG DROP
Click the Exhibits button at the bottom of the page to examine a proposed network diagram. There are four
proposed subnets, labeled A, B, C, and D. Subnet A will have 12 users, subnet B will have 300 users, subnet C
will have 118 users, and subnet D will have 61 users.

You are designing the IP addressing for this network. You are instructed not to waste IP addresses by making
the subnets larger than necessary. Click and drag the correct network ID from the left to the appropriate subnet
on the right.
Select and Place:

Which statements are TRUE regarding Internet Protocol version 6 (IPv6) addresses? (Choose three.)

Examine the following diagram:

While troubleshooting an OSPF routing problem, you need to determine the cost for Router F to reach the
192.168.5.0 24 network via the best route.
What will that cost be?

DRAG DROP
Click and drag the command line tools used to troubleshoot the network problems on the left to their associated
functions on the right. Not all commands may be used.
Select and Place: