What benefit results from implementation of Layer 3 switching versus Layer 2 switching in a fully meshed campu
What benefit results from implementation of Layer 3 switching versus Layer 2 switching in a fully meshed campus network?
Select the best response.
Which statement best describes implementing a Layer 3 EtherChannel?
Which statement best describes implementing a Layer 3 EtherChannel? Select the best response.
Which of these is true regarding the configuration and application of port access control lists?
Which of these is true regarding the configuration and application of port access control lists?
Select the best response.
which configuration task must you do first?
When configuring private VLANs, which configuration task must you do first? Select the best response.
which three of these port types?
Private VLANS can be configured as which three of these port types? (Choose three.)
Select 3 response(s).
What are three results of issuing the switchport host command?
What are three results of issuing the switchport host command? (Choose three.) Select 3 response(s).
Which of these is a tactic that you can use to mitigate compromises from being launched through the switch?
You are implementing basic switch security best practices. Which of these is a tactic that you can use to mitigate compromises from being launched through the switch? Select the best response.
what does the command aaa new-model enable?
By itself, what does the command aaa new-model enable? Select the best response.
What conclusion can you infer from this information?
Three Cisco Catalyst switches have been configured with a first-hop redundancy protocol. While reviewing some show commands, debug output, and the syslog, you discover the following information:
Jan 9 08:00:42.623: %STANDBY-6-STATECHANGE: Standby: 49:
Vlan149 state Standby -> Active
Jan 9 08:00:56.011: %STANDBY-6-STATECHANGE: Standby: 49:
Vlan149 state Active -> Speak
Jan 9 08:01:03.011: %STANDBY-6-STATECHANGE: Standby: 49:
Vlan149 state Speak -> Standby
Jan 9 08:01:29.427: %STANDBY-6-STATECHANGE: Standby: 49:
Vlan149 state Standby -> Active
Jan 9 08:01:36.808: %STANDBY-6-STATECHANGE: Standby: 49:
Vlan149 state Active -> Speak
Jan 9 08:01:43.808: %STANDBY-6-STATECHANGE: Standby: 49:
Vlan149 state Speak -> Standby
What conclusion can you infer from this information? Select the best response.
Which two items are most likely the cause of Switch1 not becoming the active router?
hostname Switch1
interface Vlan10
ip address 172.16.10.32 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers 1 5
standby 1 priority 130
hostname Switch2
interface Vlan10
ip address 172.16.10.33 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers 1 5
standby 1 priority 120
HSRP was implemented and configured on two switches while scheduled network maintenance was performed.
After the two switches have finished rebooting, you notice via show commands that Switch2 is the HSRP active router. Which two items are most likely the cause of Switch1 not becoming the active router? (Choose two.)
Select 2 response(s).