What will be the result of this configuration?
Nexus(config)# monitor session 1 Nexus(config-monitor)# source interface e2/4
Nexus(config-monitor)# destination interface e2/1
Nexus(config-monitor)# filter vlan55,56
Nexus(config-monitor)#
What will be the result of this configuration?
Which of following is taken to packets that do not match any of the route-map statements in policy-based routi
Policy-based routing (PBR) provides a mechanism for expressing and implementing
forwarding/routing of data packets based on the policies defined by the network administrators.
Which of following is taken to packets that do not match any of the route-map statements in policy-based routing?
Which command must be issued to activate the FWSM firewall context?
Which command must be issued to activate the FWSM firewall context?
If interface gig3/2 fails on Catalyst 6500 #1 how will failover proceed?
Refer to the exhibit. If interface gig3/2 fails on Catalyst 6500 #1 how will failover proceed?
Exhibit:
What information is displayed when you execute this command on the IDSM?
What information is displayed when you execute this command on the IDSM?
show settings
What is the implication of executing the command failover interface-policy 2 on an FWSM?
What is the implication of executing the command failover interface-policy 2 on an FWSM?
in a graceful restart situation?
You are the new Trainee. The lecturer asked that which of following statements is the grace period
in a graceful restart situation?
component to carry out the Graceful Restart feature?
You work as a Cisco engineer. When you deploy the company network, you must configure which
component to carry out the Graceful Restart feature?
can configure VLAN IDs and ACLs in an FCoE adapter of the Cisco Nexus 5000 Switch?
You work as a Cisco engineer. According to your judgement, in following interfaces, which one
can configure VLAN IDs and ACLs in an FCoE adapter of the Cisco Nexus 5000 Switch?
How do you enable the use of Cisco Adaptive Security Device Manager on an existing FWSM?
How do you enable the use of Cisco Adaptive Security Device Manager on an existing FWSM?