Which negotiation is initiated by setting an EtherChannel mode to auto on an interface?
Which negotiation is initiated by setting an EtherChannel mode to auto on an interface?
What will be the result of this configuration?
Nexus(config)# monitor session 1 Nexus(config-monitor)# source interface e2/4
Nexus(config-monitor)# destination interface e2/1
Nexus(config-monitor)# filter vlan55,56
Nexus(config-monitor)#
What will be the result of this configuration?
Which part can be used to resolve the case?
You are the senior desktop administrator. There is a consultation from a potential customer: When
a failure situation includes a corrupted operating system image and no connectivity per in-band
management into a Cisco Nexus 7010 Switch and the system cannot boot up.
Which part can be used to resolve the case?
With your knowledge on Cisco field, which is a considerable advantage of Cisco’s data center end-to-end
You work as a Cisco engineer at YourDomain.com. With your knowledge on Cisco field, which is a considerable advantage of Cisco’s data center end-to-end strategy?
capture on the IDSM?
Refer to the exhibit. Given this network design, which command would you use to configure traffic
capture on the IDSM?
Exhibit:
how are DHCP messages authenticated in the DHCP snooping process?
You work as a Cisco engineer. You know Dynamic Host Configuration Protocol (DHCP) well, so
how are DHCP messages authenticated in the DHCP snooping process?
which of the following information the DCNM initial discovery ?
You are a Cisco engineer. You are maintaining the company network, as much as you know,
which of the following information the DCNM initial discovery ?
What is required when configuring NTP on the IDSM?
What is required when configuring NTP on the IDSM?
what occurs with the MAC address of the standby Hot Standby Router Protocol (HSRP) router?
You work as the network administrator. You are testing the company network while during failover,
what occurs with the MAC address of the standby Hot Standby Router Protocol (HSRP) router?
permitted in each context?
How can a customer with multiple FWSM contexts limit the number of connections that are
permitted in each context?