You have completed a site survey for a customer that refurbishes/remanufactures automobile engines. The site survey has determined that there are approximately 70 clients in the facility, but because of the large number of engines as many as 2500 RFID tags will need to be tracked through location services to provide historical location information and audit trails. The results of the site survey require 60 APs for data and location services. How many version 7.0 controller(s) will provide the most cost effective solution?

Customer requirements and a WLAN site survey require a Cisco 1250 AP operating at full 802.11a/b/g/n located approximately 150 meters from the closest IDF. What is the best solution to provide wireless coverage to this portion of the customer’s facility?

Refer to the exhibit.

14

After performing a Layer 1 survey using Cisco Spectrum Expert, what is the result indicated by the visual screen?

Refer to the exhibit.

13

After performing a Layer 1 survey using Cisco Spectrum Expert, what is the result indicated by the visual screen?

Refer to the exhibit.

12

After performing a Layer 1 survey using Cisco Spectrum Expert, what is the result indicated by the visual screen?

Which item is more of an issue to outdoor wireless mesh deployment than indoor?

What is the vertical height that a MAP should not exceed for proper deployment?

Mesh APs are commonly mounted alongside a pole, meaning they are both vertically aligned and the pole could partially block the mesh AP RF signal. What is the maximum degree angle to allow for blockage of the antenna field of view?

Which two basic factors have the most influence on the size of the Fresnel zone of an outdoor RF point-to-point link? (Choose two.)

Which two statements best describe the Fresnel zone related to an outdoor RF point-to-point link? (Choose two.)