The Certkiller Lumber Company uses a centralized call processing model to connect their saw mills in Albany and Columbus. Each mill is configured as a separate Location in Cisco Unified CallManager at HQ. Each Location has been configured with 256 Kbps of voice bandwidth. How many G.729 calls can be placed between Locations simultaneously?

You have two clusters with six Cisco Unified CallManager systems in each. How many ICTs must be configured to provide full server redundancy if a gatekeeper is present in the network?

How many backup sessions can be active at one time in the Disaster Recovery System?

How are Cisco Unified CallManager location parameters used?

What is the difference between a CMR and a CDR?

A dial plan uses six-digit numbers, in which the first two digits are a site code and the last four digits are an extension. Access codes must begin with a 7 or 8 and the second digit must be a 0, 1, 5, or 9. Calls within a site are placed using just the four digit extensions. Which two route patterns will support this dial-plan requirement? (Choose two.)

Which two are requirements for configuring a gatekeeper-controlled intercluster trunk? (Choose two.)

What happens when you try to configure the fourth member of a Cisco Unified CallManager group?

Certkiller Lumber Company phones are configured to use AAR to reroute a call when the call is rejected due to insufficient IP WAN bandwidth. Which AAR configuration parameter will prevent a call originating at a lobby phone from using AAR when CAC rejects the call due to insufficient bandwidth?

You need to configure a new IOS-based Catalyst switch to support voice and data VLANs. The data VLAN will be VLAN 10 and the voice VLAN will be VLAN 100. Which of the following configurations should be used to support these VLANs while also allowing switch port 0/1 to enter the forwarding state immediately?