What H.323 gatekeeper feature allows calls to be routed to a specific zone, regardless of the zone prefix in t
What H.323 gatekeeper feature allows calls to be routed to a specific zone, regardless of the zone prefix in the address?
what IP address will GK1 use to send and receive RAS messages?
Given the following configuration, what IP address will GK1 use to send and receive RAS messages?
GK1(config)#interface serial 0/0/0
GK1(config-if)#ip address 192.168.0.2 255.255.255.0
GK1(config-if)#exit
GK1(config)#interface serial 0/0/1
GK1(config-if)#ip address 172.16.0.2 255.255.255.0
GK1(config-if)#exit
GK1(config)#gatekeeper
GK1(config-gk)#zone local SanJose cisco.com 172.16.0.2
GK1(config-gk)#zone remote Austin cisco.com 192.168.0.1
GK1(config-gk)#zone prefix SanJose 2…
GK1(config-gk)#zone prefix Austin 3…
what priority does it use as a default?
An H.323 gatekeeper maintains a separate gateway list, ordered by priority, for each of its zone prefixes. If a gateway does not have an assigned priority for a zone prefix, what priority does it use as a default?
How much bandwidth does an H.323 gatekeeper assume will be required by a G.729 call?
How much bandwidth does an H.323 gatekeeper assume will be required by a G.729 call?
What parameter of the bandwidth command, used in gatekeeper configuration mode, specifies the maximum amount o
What parameter of the bandwidth command, used in gatekeeper configuration mode, specifies the maximum amount of bandwidth that can be allocated in a zone?
Where should RAI be configured?
Where should RAI be configured?
Which of the following best describes a function of RTCP?
Which of the following best describes a function of RTCP?
What is the mostly likely cause of this problem?
You have received a trouble ticket stating that users are no longer hearing a second dial tone after pressing 9 to initiate an external call. The trouble ticket states that the second dial tone is played only after several additional digits are dialed.What is the mostly likely cause of this problem?
Which Cisco Unity troubleshooting tool would you use to diagnose problems with skinny and MWI messages?
You are in charge of Troubleshooting Cisco Unified Communications in compny Which Cisco Unity troubleshooting tool would you use to diagnose problems with skinny and MWI messages?
What should be done to correct this issue?
Refer to the exhibit.
You have received a trouble ticket that two engineers at the HQ site tried to conference at a user location at the Branch site and the ad-hoc conference failed. Further investigation reveals that the remote user can occasionally be conferenced in. Phones are configured to use G.711 for intra-site calls and G.729 for inter-site calls. All phones at the remote site are configured to use MRGL_Branch, which contains only the media resource group named BRANCH.
What should be done to correct this issue?