What should be used to allow such a deployment?
Refer to the exhibit.
A customer wants to deploy an FCIP-based connectivity to three remote sites. To achieve that, 18/4 MSMs at a central site and on each of the remote sites are connected through a single Layer 2 Ethernet connection through an Ethernet switched network. To follow the IP addressing scheme, the FCIP sessions must be in separate IP subnets. What should be used to allow such a deployment? Select the best response.
What happens when larger Fibre Channel frames are received by the MDS switch?
The 18/4 MSM module uses the FCIP with standard Ethernet MTU size of 1518 bytes. What happens when larger Fibre Channel frames are received by the MDS switch? Select the best response.
What should the service provider’s equipment support to maximize the FCIP throughput with minimum overhe
A customer is about to deploy a primary and secondary data center using the service provider’s network to connect the data center’s IP and Fibre Channel networks to connect the SAN island with FCIP tunnels. What should the service provider’s equipment support to maximize the FCIP throughput with minimum overhead? Select the best response.
what tool would aid in setting up the proper WAN parameters?
When connecting two Fibre Channel networks across an IP network, what tool would aid in setting up the proper WAN parameters? Select the best response.
Which option should be used to ensure the lowest possible downtime during the migration process?
Which option should be used to ensure the lowest possible downtime during the migration process? Select the best response.
50
How should the inter-site connectivity be accomplished?
A customer recently deployed four Cisco MDS 9222i Multilayer Fabric Switches, two at each location. The locations are approximately 150 km apart. The customer will use the FCIP connectivity for backup to the remote site. The backup server generally requires approximately 6 Gb/s of throughput to keep tapes streaming and has two 8-Gb/s Fibre Channel host bus adapters. How should the inter-site connectivity be accomplished? Select the best response.
What is the most cost-effective solution?
Refer to the exhibit.
49
A customer has two sites with separate SAN setups and Brocade switches. The customer is considering using the sites for disaster recovery purposes and needs to connect them. The sites are about 150 km apart. The bandwidth required is estimated to be less than 800 Mb/s.What is the most cost-effective solution? Select the best response.
Which interop mode would you choose to maintain the maximum feature set on both sides of the SAN?
A customer wants to connect a McData switch to your Cisco MDS SAN. Which interop mode would you choose to maintain the maximum feature set on both sides of the SAN? Select the best response.
What is the proper procedure to replace existing Fibre Channel switches with Cisco MDS switches to ensure mini
Refer to the exhibit.
48
What is the proper procedure to replace existing Fibre Channel switches with Cisco MDS switches to ensure minimum downtime? Select the best response.
What are two recommended ways for protecting the management access to a Cisco MDS switch?
What are two recommended ways for protecting the management access to a Cisco MDS switch? (Choose two.)