How can you specify primary and secondary paths for each FCIP tunnel?
You are implementing an FCIP solution for SAN extension between two data centers using the Cisco MDS 9000 Series platform. For redundancy, there are two Metro Ethernet paths between the data centers. How can you specify primary and secondary paths for each FCIP tunnel?
What information does the command show flogi database provide?
What information does the command show flogi database provide?
What is the impact of this choice during zoneset activation?
During initial switch configuration, the administrator elects to enable full zoneset distribution. What is the impact of this choice during zoneset activation?
what three technologies to protect against unauthorized management access?
The MDS 9000 family switches use what three technologies to protect against unauthorized management access? (Choose three.)
Which error was made at initial configuration?
After performing the initial switch configuration by running the setup utility, an administrator notices that ports configured to connect to other Cisco MDS 9000 switches invariably come up as E_Ports rather than TE_Ports. Which error was made at initial configuration?
how many bits in the IPv4 address are used to identify the network?
On a Class C IP network, how many bits in the IPv4 address are used to identify the network?
What does this mean?
While examining the output of a show run command on the Cisco MDS 9000 Series, you notice that the statement interface GigabitEthernet2/1.2 appears in the output. What does this mean?
Which of these switch port types should the port be set to?
You have been asked to configure a port on your Cisco MDS switch so that a host can join your fabric. Which of these switch port types should the port be set to?
What two commands must be executed on an MDS 9000 family switch in order to change a dynamically assigned Doma
What two commands must be executed on an MDS 9000 family switch in order to change a dynamically assigned Domain ID 5 to a static Domain ID 10 for VSAN 10? Choose two.
Which two of these environments suggest the use of FCIP Write Acceleration?
Which two of these environments suggest the use of FCIP Write Acceleration? (Choose two.)