What can be changed in the most cost-effective way with the biggest impact to improve the continuity of a Cisc
What can be changed in the most cost-effective way with the biggest impact to improve the continuity of a Cisco TelePresence room?
Which is the cause of the problem?
Refer to the exhibit. You are using Cisco Telepresence Manager and have just added a new room in the Cisco Unified Communications Manager and have made test calls successfully. You run the Discover Rooms option under Discovery Service successfully. You then go into the Rooms section and see the status. Which is the cause of the problem?
What is the minimum recommended distance for the LCD bezel to the far edge of the table?
You are installing a CTS-1300 with a long straight cable. What is the minimum recommended distance for the LCD bezel to the far edge of the table?
What is the minimum recommended distance for participant chair spacing?
You are installing a CTS-1300 with a long straight cable. What is the minimum recommended distance for participant chair spacing?
Which is the cause of the problem?
Refer to the exhibit. You have created a profile in the Cisco Unified Communications Manager for a new Telepresence room with the MAC address 00:19:AA:04:4E:AE. You log into the Cisco Telepresence Manager and you enter the Discovery Service and select the Discover Rooms button. When you check the Rooms listing under the Cisco Telepresence Manager, you do not see the new room listed. You then inspect the DiscoveryMgr_audit.log file. Which is the cause of the problem?
Which statement is incorrect when a Cisco Telepresence System is used for contact center integration with UCCX
Which statement is incorrect when a Cisco Telepresence System is used for contact center integration with UCCX?
Which bandwidth is used by Cisco TelePresence CTS-1000 for sending audio during an active call that excludes c
Which bandwidth is used by Cisco TelePresence CTS-1000 for sending audio during an active call that excludes collaboration and audio add-in?
which command is the correct syntax to get the list of all services running?
On a Cisco TelePresence CLI, which command is the correct syntax to get the list of all services running?
What are the expected results once these measurements are submitted with the RRA?
During your RRA assessment of a potential Cisco TelePresence System 3000 room you notice:
* When you acquire the average lux level measurements, all zones result with lux levels
between 268 and 290 on the vertical plane and between 604 and 678 on the horizontal plane. What are the expected results once these measurements are submitted with the RRA?
Which two problems are displayed?
The Cisco Device Manager screen shows multiple problems in a SAN environment. Which two problems are displayed? (Choose two.)