PrepAway - Latest Free Exam Questions & Answers

Category: 300-410

Exam 300-410: Implementing Cisco Enterprise Advanced Routing and Services (ENARSI)

In the Active Discovery phase of PPPoE, which of the following is NOT verified by the Broadband Network gatewa

In the Active Discovery phase of PPPoE, which of the following is NOT verified by the Broadband Network gateway (BNG) to prevent spoofing? A. source MAC address B. arriving access interface C. PPPoE session ID D. destination MAC address Explanation: The destination MAC address is the address of the BNG, so there is no need […]

You are configuring a 6to4 tunnel. You want to translate the IPv4 address 192.168.50.4 to the IPv6 address for

You are configuring a 6to4 tunnel. You want to translate the IPv4 address 192.168.50.4 to the IPv6 address for the tunnel. What would be the correct translation? A. 2002:c0a8:3204::/16 B. 2002:c0a8:9901::/48 C. 2002:c0a8:3204::/48 D. c0a8:3204:2002::/16 Explanation: When implementing an automatic 6to4 tunnel, each IPv6 site receives a /48-bit prefix. The hexadecimal equivalent of the IPv4 […]

You just discovered that a ping packet sent from one of the devices to another took a different path in the re

You just discovered that a ping packet sent from one of the devices to another took a different path in the return than it did on its way to the destination. What behavior caused this? A. Windowing B. Global synchronization C. MSS D. Asymmetric routing Explanation: This behavior is caused by asymmetric routing. This is […]

Which of the following are valid IPv4 to IPv6 migration strategies? (Choose two.)

Which of the following are valid IPv4 to IPv6 migration strategies? (Choose two.) A. DHCP B. Tunnels C. Dual-stack D. Encapsulating IPv4 into IPv6 Explanation: Tunnels and dual-stack are valid IPv4 to IPv6 migration strategies. Tunneling mechanisms can transport IPv6 across an IPv4 infrastructure. Cisco supports the following types of tunneling for this purpose: • […]

What possible reason(s) can cause the state of the first entry in the adjacency table? (Choose all that apply.

Examine the following output. What possible reason(s) can cause the state of the first entry in the adjacency table? (Choose all that apply.) A. the interface is a multipoint interface B. the clear ip arp command was executed C. the Layer 3 information is unknown D. the clear adjacency command was executed Explanation: If either […]


Page 3 of 512345