You have been asked to configure a Cisco ASA appliance in multiple mode with these
settings:
A) You need two customer contexts, named contextA and contextB.
B) Allocate interfaces G0/0 and G0/1 to contextA.
C) Allocate interfaces G0/0 and G0/2 to contextB.
D) The physical interface name for G0/1 within contextA should be “inside”.
E) All other context interfaces must be viewable via their physical interface names.
If the admin context is already defined and all interfaces are enabled, which command
set will complete this configuration?

A.
context contextA
config-url disk0:/contextA.cfg
allocate-interface GigabitEthernet0/0 visible
allocate-interface GigabitEthernet0/1 inside
context contextB
config-url disk0:/contextB.cfg
allocate-interface GigabitEthernet0/0 visible
allocate-interface GigabitEthernet0/2 visible

B.
context contexta
config-url disk0:/contextA.cfgallocate-interface GigabitEthernet0/0 visible
allocate-interface GigabitEthernet0/1 inside
context contextb
config-url disk0:/contextB.cfg
allocate-interface GigabitEthernet0/0 visible
allocate-interface GigabitEthernet0/2 visible

C.
context contextA
config-url disk0:/contextA.cfg
allocate-interface GigabitEthernet0/0 invisible
allocate-interface GigabitEthernet0/1 inside
context contextB
config-url disk0:/contextB.cfg
allocate-interface GigabitEthernet0/0 invisible
allocate-interface GigabitEthernet0/2 invisible

D.
context contextA
config-url disk0:/contextA.cfg
allocate-interface GigabitEthernet0/0
allocate-interface GigabitEthernet0/1 inside
context contextB
config-url disk0:/contextB.cfg
allocate-interface GigabitEthernet0/0
allocate-interface GigabitEthernet0/2

E.
context contextA
config-url disk0:/contextA.cfg
allocate-interface GigabitEthernet0/0 visible
allocate-interface GigabitEthernet0/1 inside
context contextB
config-url disk0:/contextB.cfg
allocate-interface GigabitEthernet0/1 visible
allocate-interface GigabitEthernet0/2 visible