The following configuration commands exist only in an implementation plan document.
An engineer does a copy/paste of these commands into configuration mode on Router R1.
Which of the following answers is most accurate regarding the results?
ip sla 1
icmp-echo 1.1.1.1 source-ip 2.2.2.2
ip sla schedule 1 start-time now life forever

The following output occurs on Router R1. IP SLA operation 1 uses an ICMP echo operation
type, with default frequency of 60 seconds. The operation pings from address
1.1.1.1 to address 2.2.2.2. Which of the following answers is true regarding IP SLA and
object tracking on R1?
R1# show track
Track 2
IP SLA 1 state
State is Up
3 changes, last change 00:00:03
Delay up 45 secs, down 55 secs
Latest operation return code: OK
Latest RTT (millisecs) 6
Tracked by:
STATIC-IP-ROUTING 0

Which of the following are considered private IPv4 addresses? (Choose two.)

Class C network 200.1.1.0/24 was allocated to an ISP that operated primarily in Asi

Router R1, in ASN 11, learns a BGP route from BGP peer R22 in ASN 22. R1 and then uses
BGP to advertise the route to R2, also in ASN 11. What ASNs would you see in the BGP
table on R2 for this route?

Which of the following are most likely to be used as an ASN by a company that has a
registered public 16-bit ASN? (Choose two.)

Which of the following statements is true about a router’s eBGP peers that is not also true
about that same router’s iBGP peers?

Which of the following is the primary motivation for using BGP between an Enterprise and its
ISPs?

The following terms describe various design options for Enterprise connectivity to the
Internet. Which of the following imply that the Enterprise connects to two or more ISPs?
(Choose two.)

Enterprise Router R1, in ASN 1, connects to ISP Router I1, ASN 2, using eBGP. The single
serial link between the two routers uses IP addresses 10.1.1.1 and 10.1.1.2, respectively.
Both routers use their S0/0 interfaces for this link. Which of the following commands would
be needed on R1 to configure eBGP? (Choose two.)