Refer to the exhibit. You have completed an OSPF implementation, and you are verifying
OSPF operation. You notice that router A and router B are stuck in the two-way state. From
the show ip ospf interface command output, what is the cause of this issue?
Select the best response.

You have completed an OSPF implementation, and you are verifying OSPF operation.
During this verification, you notice that the OSPF route of 172.16.10.0 is repeatedly
appearing and disappearing from the routing table. Further investigation finds that the OSPF
CPU utilization is very high and the routers are constantly performing SPF calculations. You
determine that 172.16.20.2 is the source of the 172.16.10.0 route. Using the show ip ospf
database router 172.16.20.1 command, you notice that when this show command is
performed repeatedly, the contents of the LSA change every few seconds.
What could be the cause of this problem? Select the best response.

When an OSPF design is planned, which implementation can help a router not have memory
resource issues? Select the best response.

The maximum number of routers per OSPF area typically depends on which three factors?
(Choose three.) Select 3 response(s).

You are troubleshooting an OSPF problem where external routes are not showing up in the
OSPF database. Which two options are valid checks that should be performed first to verify
proper OSPF operation? (Choose two.) Select 2 response(s).

When verifying the OSPF link state database, which type of LSAs should you expect to see
within the different OSPF area types? (Choose three.) Select 3 response(s).

When verifying OSPF virtual link problems, which is an important item to check on the two
transit OSPF routers? Select the best response.

You are developing a verification plan for an upcoming OSPF implementation. Part of this
plan is to verify the status of type 3 LSAs within the network. Which routers should you verify
first to ensure that the configurations are correct for generating type 3 LSAs?
Select the best response.

Which condition must be satisfied before an EIGRP neighbor can be considered a feasible
successor?
Select the best response.

Based on the need to limit processing and bandwidth utilization due to dynamic routing
protocol operation, the following routing requirements have been specified for your network.
– partial and incremental routing updates
– only the devices affected by a topology change perform route recomputation
– route recomputation only occurs for routes that were affected
Which dynamic routing protocol should be deployed in your network to best meet these
requirements?
Select the best response.