Which EIGRP packet statement is true?

EIGRP has been configured to operate over Frame Relay multipoint connections. What
should the bandwidth command be set to?

Refer to the exhibit. Router R1 is connected to networks 172.16.1.0 /26 and 172.16.1.64 /27.
On the basis of the partial output in the exhibit, which statement is true?

Based on the exhibited output, which three statements are true? (Choose three.)

After DUAL calculations, a router has identified a successor route, but no routes have
qualified as a feasible successor. In the event that the current successor goes down, what
process will EIGRP use in the selection of a new successor?

Which three statements about the EIGRP routing protocol are true? (Choose three.)

Which three statements are true about EIGRP route summarization? (Choose three.)

Refer to the exhibit. Routers R1 and R2 are running EIGRP and have converged. On the
basis of the information that is presented, which statement is true?

Refer to the exhibit. Which two statements are true? (Choose two.)

A router has been configured with the commands router eigrp 9 and network
172.16.1.0 0.0.0.255. No other EIGRP-related commands have been configured. The
answers list the IP addresses that could be assigned to this router’s Fa0/0 interface. Which
answers list an IP address/prefix length that would cause the router to enable EIGRP on
Fa0/0?