Refer to the exhibit.

Which configuration is missing to complete the configuration task of enabling BFD with the
192.168.1.1 EBGP peer?

Which two features are used to provide high availability multicast? (Choose two.)

What are three BGP configuration characteristics of a multihomed customer that is connected
to multiple service providers? (Choose three.)

Refer to the EBGP configuration on a PE IOS-XR router exhibit.
After the EBGP configuration, no routes are accepted from the EBGP peer, nor are any routes
advertised to the EBGP peer.

What could be the problem?

Refer to the exhibit.

The following multicast IP addresses map to which multicast MAC address?

A junior network engineer has just configured a new IBGP peering between two Cisco
ASR9K PE routers in the network using the loopback interface of the router, but the IBGP
neighborship is not able to be established. Which two verification steps will be helpful in
troubleshooting this problem? (Choose two.)

Refer to the exhibit for the outputs from an ASR9K router.

Why did the ping fail?

Which multicast routing protocol supports dense mode, sparse mode and bidirectional mode?

When configuring BFD, the multiplier configuration option is used to determine which
value?

After configuring the tunnel interface as shown in the exhibit, no IPv6 traffic is passed over
the IPv4 network.
Which additional configuration is required to pass the IPv6 traffic over the IPv4 network?