What are two purposes of the BGP scan-time command? (Choose two.)

When using the show bgp ipv6 unicast summary command to verify the IPv6 BGP session status with
the IPv6 BGP peers, you noticed the “St/PfxRcd” status for one of the IPv6 BGP peers is in the
“Active” state. What does the “Active” state indicate?

Which three BGP configuration groupings are supported on Cisco IOS XR Software? (Choose three.)

What is recursive lookup in BGP and how does it work?

Which AS path access list is used by a multihomed customer to only announce their own address
space to their service providers to prevent the multihomed customer from becoming a transit AS?

Which reserved AS number or range of numbers is used for backward compatibility between old BGP
peers using 16-bit AS number and new BGP peers using 32-bit AS number?

Which BGP attribute is a set of generic tags that can be used to signal various routing policies
between BGP routers?

Which of the following is a characteristic of dual-multihomed connectivity between an enterprise
network and the service provider network or networks?

What are two ways to advertise networks into BGP? (Choose two.)

Refer to the network diagram in the exhibit.

Assuming the IBGP session within AS 64500 was established using the loopback 0 interface between
the two routers, by default, what will be the next hop of the routes from AS 64501 when the routes
appear on the router running IBGP only in AS 64500?