When configuring VPLS on the Cisco ASR 9000, which three configurations are required under
the l2vpn configuration mode? (Choose three.)

Which option is the correct command to define an interface as Layer 2 on the Cisco ASR 9000?

When implementing MPLS Layer 3 VPN services, which CE-PE routing method does not require
the use of the redistribute command to enable the customer routes to be advertised through the
MPLS cloud between the customer sites?

In MPLS Layer 3 VPN implementations, what is used at the PEs to transform the customer IPv4
prefixes into a unique 96-bit prefix?

With Layer 3 MPLS VPN implementations on Cisco IOS XR PE routers, an interface is assigned to
a VRF using the vrf command in which configuration mode?

Refer to the partial Cisco IOS XR PE router configuration exhibit for supporting a Layer 3 MPLS
VPN customer using EIGRP AS 20 as the CE-to-PE routing protocol.

The MPLS VPN customer is having problems receiving the EIGRP routes on the different
customer site CE routers. What is wrong with this configuration that is causing the problem?

In which Cisco IOS XR configuration mode is the redistribute static command applied to enable
the redistribution of static VRF routes between the PE routers?

What is required on a Cisco IOS XR router to assign an interface to a VRF?

When implementing VPLS on Cisco IOS XR routers, the VPLS PW neighbors can be statically
defined under which configuration mode?

On Cisco IOS XR platforms using the EVC infrastructure, which command is used to enable a
Layer 2 VPN subinterface?