In Layer 3 MPLS VPN implementations, if some of the VPNv4 routes on one PE router do not
appear on another PE router, what could be the problem?

When implementing CSC services, which two methods can be used to exchange label information
between the downstream CSC customer carrier and the CSC backbone carrier? (Choose two.)

The Cisco IOS XR address-family ipv4 labeled-unicast and the Cisco IOS/IOS XE neighbor sendlabel commands are used in which MPLS implementation?

When verifying Layer 3 MPLS VPN operations, which Cisco IOS XR show command is best used
to verify that the PE router is receiving the routes from the CE router?

When implementing Layer 3 MPLS VPNs on Cisco IOS/IOS XE PE routers, which PE-to-CE
routing protocol requires a separate routing process to be created for each VRF?

In Layer 3 MPLS VPN implementations, if a customer is using the same AS number at both
customer sites and the PE-to-CE routing protocol is BGP, what must be enabled on the PE router?

Which three functions are performed by the PE router in an MPLS Layer 3 VPN? (Choose three.)

Which BGP extended community is used to control the distribution of VPN routing information and
to identify routers that may receive a set of routes that carry the community?

In which configuration mode is a route distinguisher configured in a Cisco IOS XR router?

Refer to the exhibit.

Given the output shown, which two statements are true? (Choose two.)