which the IGP protocol is enabled?
Which Cisco IOS XR command should be used in order to enable LDP on all interfaces for which the
IGP protocol is enabled?
what could be the possible root cause of the LDP peering problem?
Refer to the partial Cisco IOS XR configurations exhibit for Router 1 and Router 2.
There are two routers that are connected back to back over the Gigabit Ethernet link. If the “show
mpls ldp neighbor” command output on Router 1 does not show LDP peering with Router 2, what
could be the possible root cause of the LDP peering problem?
Which Cisco IOS XR command should be used to identify if MPLS TE FRR is enabled?
Which Cisco IOS XR command should be used to identify if MPLS TE FRR is enabled?
Which feature minimizes traffic loss and provides faster convergence after the link is re-established?
When a link flaps, an mpls ldp session will also flap. Which feature minimizes traffic loss and
provides faster convergence after the link is re-established?
which IP precedence value?
A DSCP value of 41 in decimal corresponds to which IP precedence value?
what is the label value used to reach the 10.7.1.1/32 network prefix?
Scenario:
On the PE8-router what is the label value used to reach the 10.7.1.1/32 network prefix?
Drag the MPLS Diff-Serv Tunneling mode on the left to match the correct description on the right.
DRAG DROP
Drag the MPLS Diff-Serv Tunneling mode on the left to match the correct description on the right.
Drag the QOS model on the left to match its correct description on the right.
DRAG DROP
Drag the QOS model on the left to match its correct description on the right.
Put the Mpls LDP steps on the left into the correct order from top to bottom on the right.
DRAG DROP
Put the Mpls LDP steps on the left into the correct order from top to bottom on the right.
Drag the Cisco MQC configuration task on the left to match the correct description on the right.
DRAG DROP
Drag the Cisco MQC configuration task on the left to match the correct description on the right.
