Refer to the exhibit.

Which authentication method was used by the remote peer to prove its identity?

Refer to the exhibit.

An IPsec peer is exchanging routes using IKEv2, but the routes are not installed in the RIB.
Which configuration error is causing the failure?

Refer to the exhibit.

An administrator is adding IPv6 addressing to an already functioning tunnel. The administrator
is unable to ping 2001:DB8:100::2 but can ping 209.165.200.226. Which configuration needs to
be added or changed?

Refer to the exhibit.

The IKEv2 tunnel between Router1 and Router2 is failing during session establishment. Which
action will allow the session to establish correctly?

You are troubleshooting a site-to-site VPN issue where the tunnel is not establishing. After
issuing the debug crypto isakmp command on the headend router,you see the following
output. What does this output suggest?
1d00h: ISAKMP (0:1): atts are not acceptable. Next payload is 0
1d00h: ISAKMP (0:1); no offers accepted!1d00h: ISAKMP (0:1): SA not acceptable!
1d00h: %CRYPTO-6-IKMP_MODE_FAILURE. Processing of Main Mode failed with peer at
10.10.10.10

You are troubleshooting a site-to-site VPN issue where the tunnel is not establishing. After
issuing the debug crypto ipsec command on the headend router,you see the following output.
What does this output suggest?
1d00h: IPSec (validate_proposal): transform proposal
(port 3, trans 2, hmac_alg 2) not supported
1d00h: ISAKMP (0:2) : atts not acceptable. Next payload is 0
1d00h: ISAKMP (0:2) SA not acceptable

After completing a site-to-site VPN setup between two routers, application performance over
the tunnel is slow. You issue the show crypto ipsec sa command and see the following output.
What does this output suggest?
interfacE. Tunnel100
Crypto map tag: Tunnel100-head-0, local addr 10.10.10.10
protected vrF. (none)
local ident (addr/mask/prot/port): (10.10.10.10/255.255.255.255/47/0)
remote ident (addr/mask/prot/port): (10.20.20.20/255.255.255.255/47/0)
current_peer 209.165.200.230 port 500
PERMIT, flags={origin_is_acl,}
#pkts encaps: 34836, #pkts encrypt: 34836, #pkts digest: 34836
#pkts decaps: 26922, #pkts decrypt: 19211, #pkts verify: 19211
#pkts compresseD. 0, #pkts decompresseD. 0
#pkts not compresseD. 0, #pkts compr.faileD. 0
#pkts not decompresseD. 0, #pkts decompress faileD. 0
#send errors 0, #recv errors 0

Which adaptive security appliance command can be used to see a generic framework of the
requirements for configuring a VPN tunnel between an adaptive security appliance and a Cisco
IOS router at a remote office?

Which Cisco adaptive security appliance command can be used to view the count of all active
VPN sessions?

Refer to the exhibit.

An administrator had the above configuration working with SSL protocol, but as soon as the
administrator specified IPsec as the primary protocol, the Cisco AnyConnect client was not able
to connect. What is the problem?