Interface tunnel 1
ip address 10.1.1.1 255.255.255.252
ip mtu 1400
Tunnel source 172.16.1.1
Tunnel destination 172.16.1.2
Tunnel key 1111
Based on the above configuration, if the input packet size is 1300 bytes, what is the size
of the packet leaves the tunnel after encapsulation?

You run the show ipv6 port-map telnet command and you see that the port 23 (systemdefined) message and the port 223 (user-defined) message are displayed. Which
command is in the router configuration?

At the end of the Cisco TrustSec authentication process, which three pieces of
information do both authenticator and supplicant know? (Choose three.)

You are preparing Control Plane Protection configurations for implementation on the
router, which has the EBGP peering address 1.1.1.2. Which ACL statement can you use
to classify the related traffic into the EBGP traffic compartment?

Which command enables fast-switched PBR?

Which series of steps illustrates the correct flow for incident management?

Which of these configurations shows how to configure MPP when only SSH, SNMP, and
HTTP are allowed to access the router through the Gigabit Ethernet 0/3 interface and
only HTTP is allowed to access the router through the Gigabit Ethernet 0/2 interface?

Which two EAP methods may be susceptible to offline dictionary attacks? (Choose two.)

Refer to the exhibit.

Which three fields of the IP header labeled can be used in a spoofing attack? (Choose
one.)

What type of attack consists of injecting traffic that is marked with the DSCP value of EF
into the network?