Your Cisco network currently runs OSPF and you have a need to policy-route some specific traffic, regardless of what the routing table shows. Which one of these options would enable you to policy-route the traffic?

In your Cisco EIGRP network, you notice that the neighbor relationship between two of your routers was recently restarted. Which two of these choices could have made this occur? (Choose two.)

Router 1 is configured for BGP as dual-homed on the Cisco network. Which three BGP attributes are carried in every BGP update on this router (both IBGP and EBGP)? (Choose three.)

In BGP routing, what does the rule of synchronization mean?

You have a router running BGP for the MPLS network and OSPF for the local LAN network at the sales office. A route is being learned from the MPLS network that also exists on the OSPF local network. It is important that the router chooses the local LAN route being learned from the downstream switch running OSPF rather than the upstream BGP neighbor. Also, if the local OSPF route goes away, the BGP route needs to be used. What should be configured to make sure that the router will choose the LAN network as the preferred path?

Which two protocols can have their headers compressed through MQC? (Choose two.)

What is the default maximum reservable bandwidth (percentage) by any single flow on an interface after enabling RSVP?

You are responsible for network monitoring and need to monitor traffic over a routed network from a remote source to an IDS or IPS located in the headquarters site. What would you use in order to accomplish this?

Which of the following describes the appropriate port assignment and message exchange in a standard TFTP transaction?

Which RMON group stores statistics for conversations between sets of two addresses?