How can you configure a router that carries both Internet and VPNv4 routes so that it will only propagate the
How can you configure a router that carries both Internet and VPNv4 routes so that it will only propagate the VPNv4 routes and not the Internet routes to the 10.1.1.1 BGP neighbor?
How is route target (RT) information attached to a VPNv4 route?
How is route target (RT) information attached to a VPNv4 route?
Which statement is true about the use of EBGP as the CE-PE routing protocol in MPLS VPN implementations?
Which statement is true about the use of EBGP as the CE-PE routing protocol in MPLS VPN implementations?
Which two attributes in BGP are used to help with implementation of the OSPF super-backbone?
Which two attributes in BGP are used to help with implementation of the OSPF super-backbone? (Choose two)
What explains this configuration?
The VPN named my_vpn is operating on interface s0/0 of a PE-router. The CE-PE routing protocol is RIP. The MPLS backbone IGP is OSPF. However, when you review the configuration for the PE-router, you find that BGP has been configured.
What explains this configuration?
which three route exchange mechanisms?
BGP address families are used to configure which three route exchange mechanisms? (Choose three)
Which three statements about the traditional OSPF routing model are true?
Which three statements about the traditional OSPF routing model are true? (Choose three)
how many VPN OSPF process can run simultaneously in an MPLS VPN PE-router?
In Cisco IOS release 12.1, how many VPN OSPF process can run simultaneously in an MPLS VPN PE-router?
Why is the OSPF super-backbone needed in MPLS VPN environments?
The VPN named my_vpn is operating on interface s0/0 of a PE-router. The CE-PE routing protocol is OSPF.
Why is the OSPF super-backbone needed in MPLS VPN environments?
what LSA type on the destination CE router?
An OSPF LSA type 5 route is redistributed into MP-BGP. That same route is then redistributed back from MP-BGP into OSPF on another PE router. In this case, that OSPF route will appear as what LSA type on the destination CE router?