Which two privileged mode cisco ios commands can be used to determine a cisco router chassis serial number?
Which two privileged mode cisco ios commands can be used to determine a cisco router chassis serial number?(choose two)
which of these determinations?
ip address 192.168.2.1 255.255.255.0
ip nat inside
no shutdown
!
ip nat inside source list NAT interface fastEthernet0/0 overload extended !
ip access-list extended crypto _ACL
permit ip 192.168.2.0 0.0.0.255 any
You issue the show crypto ipsec sa command and see that the tunnel is up, but no packets are encrypted or decrypted on either side. To test connectivity, you sourced a ping from the private interface of each router , destined to the private interface of the far-end router. You ask a VPN expert to help you troubleshoot. The expert has verified that ESP is not being blocked , and the routing is correct.
After some troubleshooting, the expert makes which of these determinations?
which circumstance are multiple copies of the same unicast frame likely to be transmitted in a switched LAN?
In which circumstance are multiple copies of the same unicast frame likely to be transmitted in a switched LAN?
what is causing the IKE Main Mode failure?
Referring to the debug output shown below, what is causing the IKE Main Mode failure? 1d00h: ISAKMP (0:1): atts are not acceptable. Next payload is 0 1d00h: ISAKMP (0:1): no offers accepted!
1d00h: ISAKMP (0:1): SA not acceptable!
1d00h: %CRYPTO-6-IKMP_MODE_FAILURE: Processing of Main Mode failed with peer at 150.150.150.1
which ACL can be used?
A network engineer wants to allow a temporary entry for a remote user with a specific usename and password so that the user can access the entire network over the internet, which ACL can be used?
Which two of these properties does the UDP protocol itself provide?
Which two of these properties does the UDP protocol itself provide? (Choos two)
What would be the effect of issuing the command ip access-group 114to lo the fa0/0 interface?
What would be the effect of issuing the command ip access-group 114to lo the fa0/0 interface?
which is the first DHCP message the client sends?
When a client that is configured for DHCP is powered on and requests an IP address, which is the first DHCP message the client sends?
which approach should you use to configure the extended vlan range(1006 through 4094) on a cisco catalyst 3750
Assuming the default switch configuration,which approach should you use to configure the extended vlan range(1006 through 4094) on a cisco catalyst 3750 series switch?
which one?
All of these tools are available from the Cisco IPS manager Express(Cisco IME) GUI except which one?