What is an important consideration that should be taken into account when configuring shaped round robin? (Exhibit)

Refer to the exhibit. A network engineer received a sudden request to prioritize voice over his Cisco network and he has decided to leverage the AutoQoS feature. Based on the output shown, which two tasks need to be performed prior to issuing the autoqos voip command in this router? (Choose two.)

Refer to the exhibit. Based on this configuration, what type of marker is achieved?

Refer to the exhibit. According to the output of the command show tag-switching forwarding-table, which four of these statements are true? (Choose four.)

Refer to the exhibit. There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B. What would be two suggestions to load-balance the traffic across both WAN links? (Choose two.)

Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?

Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider?

Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards, the exhibit shows your configuration in a local switch1. However, EtherChannel is not coming up. Which one of these statements could be a possible reason?

Refer to the exhibit. You are asked to enable redirection for a network optimization engine that will be connected directly to your company CPE. What is the correct configuration to enable redirection for traffic optimization?

Refer to the exhibit. Users from the Engineering VLAN complain that every time Business VLAN users have a network connectivity issue, the Engineering VLAN users usually have problems experiencing slow response or network connectivity problems. After troubleshooting, an unauthorized switch 2 was found. This unauthorized switch has been a regular problem, assuming the root bridge function under the spanning-tree domain and causing the

Engineering VLAN to be unstable. Which three of these actions could be suggested to fix the problem?