Which four commands are required when implementing DMVPN?
Which four commands are required when implementing DMVPN? (Exhibit)
Why?
Lookat the following network carefully. The technician has configured all routers to advertise all connected links through BGP, and P4S-R2 through P4S-R4 to advertize all connected links via OSPF. At P4S-R4, 172.30.1.0/24 is not in the local BGP table or the local routing table. Why?
What is the easiest way to load-share traffic across both trunks and maintain redundancy in case a link fails,
Refer to the exhibit. Catalyst R is the root bridge for both VLAN 1 and VLAN 2. What is the easiest way to load-share traffic across both trunks and maintain redundancy in case a link fails, without using any type of EtherChannel link-bundling?
Which statement best describes OSPF external LSAs (type 5)?
Which statement best describes OSPF external LSAs (type 5)? (Exhibit)
How could you achieve this goal?
You are a network engineer at PassGuide.com, study the exhibit carefully. The company’s network is running EIGRP and you want to change the path PG-R5 uses to reach 172.30.1.0/24 to PG-R4. How could you achieve this goal?
Which statement is true about the path or paths these two packets will take?
You work as a network engineer for the PassGuide Company. Study the exhibit carefully. In this network, PG-R1 is redistributing 10.1.5.0/24 into OSPF, and PG-R2 is originating 10.1.4.0/24 as an internal route. PG-R6 has received packets destined to 10.1.4.1 and 10.1.5.1. Which statement is true about the path or paths these two packets will take?
Which K value setting will be used to make sure that this link is not used by EIGRP when the link load reaches
You are a network technician at PassGuide.com, study the exhibit carefully. In this EIGRP network, the output of the command show interface for the link between PG-R2 and PG-R5 indicates that the link load varies between 10 and 35. Which K value setting will be used to make sure that this link is not used by EIGRP when the link load reaches 35, but can be used again when the link load drops below 20?
What will be the objective of this route map when applied to traffic passing through a router?
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?
Which will be the most likely cause of this problem?
You work as a network technician at Company.com, study the exhibit provided. You are implementing this QoS configuration to improve the bandwidth guarantees for traffic towards two servers, one with the IP address 5.5.5.5 and the other with the IP address 5.5.5.4. Even after the configuration is applied, performance does not seemto improve. Which will be the most likely cause of this problem?
which address or location will the router forward a packet sent to 192.168.32.1?
Based on the output provided in the exhibit, to which address or location will the router forward a packet sent to 192.168.32.1?